Description
Send us an enquiry
Amoriguard A-GAIN WATERBASED AR PRIMER is carefully formulated using recycled materials from two different waste streams. These materials are used to replace the conventional mineral fillers that would normally be used. Amoriguard A-GAIN WATERBASED AR PRIMER has further been formulated to have minimal levels of other undesirable components found in traditional decorative paints. These include Ammonia, Formaldehyde, APEO, MEG and VOC. The recycled materials used in the manufacture of Amoriguard A-GAIN WATERBASED AR PRIMER result in its natural colour being light grey.
Amoriguard A-GAIN WATERBASED AR PRIMER is best described as “Greener than Green” as not only have all raw materials containing undesirable components been replaced with less harmful options, but the majority of the traditional mineral fillers have also been replaced with recycled waste materials that have been processed to make them suitable for use.
Amoriguard is committed to conserving our environment by developing and marketing Decorative Paint Coatings that are both sustainable and eco-friendly.
Binder Type : Blend of New Generation Styrene Acrylic Polymers
Drying Time : Surface Dry: 1 hour (at 23°C and 50% humidity)
Hard Dry: 4 hours (at 23°C and 50% humidity)
Drying Process : Water evaporation
Over Coating : 4 hours
Viscosity : 100 – 105KU
Specific Gravity : 1,32 ±0,05kg/litre
Mass Non Volatile Content : 58,6%±2%
Volume Solids : 45,6%±2%
Spread Rate : 5-8m²/litre
DFT : 90μ@5m²/litre per coat
57μ@8m²/litre per coat
60˚ Gloss : < 2%
85˚ Sheen : < 2%
Flash Point : Water based – Not Applicable
Application Temp : >5°C <35°C
Colour Range : Light Grey
Clean Equipment With : Water
Pack Sizes : 20ltr
Coverage/Spread Rate depends largely on the condition and porosity of the substrate being painted and manner in which the product is applied.
Correct surface preparation is essential for good product performance and all surfaces should be prepared in the specified manner. Moisture content in the substrate should be as low as possible and we do not recommend painting if it is greater than 15%. Do not apply when ambient temperatures are less than 5°C or greater than 35°C. Stir Amoriguard A-GAIN WATERBASED AR PRIMER well by means of a flat paddle or mechanical mixer before applying one coat by Block Brush or Roller. Allow to dry for a minimum of 6 hours between coats.
✓ Always wear a suitable dust mask and goggles when preparing surfaces.
✓ Ensure good ventilation during application and drying.
✓ Always keep out of reach of children and animals.
✓ If accidental contact with skin, wash immediately with soap and water or a recognised skin cleaner.
✓ If accidental contact with eyes, rinse immediately with plenty of water and seek medical advice.
✓ Harmful if swallowed. Seek medical attention and do not induce vomiting.
MINIMAL TO NONE OF THESE HARMFUL SUBSTANCES
